Define the water and separation duty
State the source water, jar-test design and interpretation, coagulant sequence, separator and downstream process before comparing polymers.
A product that works in one water cannot be assumed to transfer to another turbidity, mineral or hydraulic condition.
Preserve a representative sample
Record sampling point, operating state, pH, temperature, turbidity or suspended solids, alkalinity, conductivity and upstream chemicals.
Mix the bulk sample consistently before splitting jars and retain the untreated reference.
Screen ionic profile and form
Compare coded anionic, cationic and nonionic candidates across plausible molecular ranges and powder or emulsion forms.
Charge information narrows the screen; measured clarification and downstream response decide the result.
Normalize preparation and dose
Keep active basis, stock concentration, water quality, aging, addition order and repeatable jar-test and plant mixing consistent for every candidate.
Unequal make-down or dose conversion invalidates a supplier comparison.
Measure the complete treatment result
Track treated-water turbidity or solids, settling behavior and downstream response, floc strength, separation rate, clarified-water quality, sludge volume and filter consequences.
Large visible floc is not sufficient if it breaks, carries over or shortens the filter run.
Release a bounded operating window
Link product code, lot, raw-water condition, dose basis, mixing, measurements, COA, SDS, packaging and quotation.
Revalidate after a meaningful water-source, coagulant, equipment, preparation or product change.
Separate chemistry from equipment faults
Check water change, sample handling, product identity, make-down, pump calibration, mixing and clarifier loading before changing the approved chemistry.
Change one controlled factor at a time and retain the accepted reference.
Close the technical and purchasing record
State the tested window, rejected conditions, field-trial plan, sample quantity, monthly demand, packaging, documents and destination.
Routine supply should match the traceable identity that produced the accepted result.
Translate the jar result to the clarifier
Collect enough representative water for the blank, incumbent, coded candidates, dose ladder and repeats. Record source, sample point, time, temperature, pH, turbidity or suspended solids, alkalinity and chemicals already present. Mix the bulk sample consistently before dividing jars so settling during setup does not bias the comparison.
Prepare polymer stocks on a declared active basis and use the same water, concentration, age and transfer method. Run plant-relevant rapid mixing, slower flocculation and settling periods. Record floc onset and breakage, but rank the result by clarified-water turbidity or solids, settling behavior, sludge volume and any filter consequence. Repeat the leading dose band rather than approving a single jar.
Scale up only after confirming water flow, product concentration and feed-pump calibration. The field sheet should retain sample condition, product code and lot, preparation, dose basis, mixer settings, reading times and acceptance limits. Jar testing narrows the operating window; the installed clarifier and downstream filters complete the approval.
Keep raw measurements, rejected conditions and the accepted reference with the decision. Define who owns field confirmation, which changes trigger retesting and how later lots will be checked against the same process evidence. This closes the gap between an attractive laboratory observation and a repeatable water treatment program. Record the units, analytical method, reading time and operator for every acceptance result. When the source water or production state moves outside the tested envelope, return to a controlled comparison before changing the routine product or dose. Share the approved limits with operations, laboratory, purchasing and receiving teams so technical evidence follows the material through routine supply.